Product classification: trapezoidal tooth rubber synchronous belt -XXH synchronous belt series
Product synopsis: layer rubber trapezoidal tooth synchronous belt of the belt is manufactured quality neoprene raw materials imported from Japan, skeleton layer is high quality glass fiber cord is imported from Japan, adopting high tooth surface wear-resisting layer adopts nylon 66 / do protection. The products have the characteristics of dynamic flexion, good anti-cracking, good ozone performance, aging resistance, heat resistance, oil resistance and wear resistance. Trapezoidal tooth synchronous belt models include: MXL, XL, L, H, XH, XH, XXH, T2.5, T5, T10, T20, AT5, AT10, AT20, etc.
1,It is strictly forbidden to break the XXH synchronous belt, bend it, avoid the damage of the powerful layer, and lose the use value.
2,The XXH synchronous belt should not be stored in an abnormal bending state.
3,Keep the XXH synchronous belt in the shade to avoid direct sunlight, so the synchronous belt will age easily.
4,During installation, please shorten the center distance, relax the tension wheel, and not force the belt to be loaded from the bottom of the belt wheel.
5,The teeth of XXH synchronous belt wheel must be at right angles to the running direction of the belt.
6,The parallel degree of the main axis of the active wheel and the passive wheel is controlled at the tangent = 1/1000. No axial position can directly affect the service life.
7,It is found that the XXH synchronous belt on the active wheel is sideways to one side. It should move the passive wheel to adjust and adjust the pressure of the tensioning wheel.
8,At the start, the center is changed, the XXH synchronous belt loosens, and the jumping tooth phenomenon should check whether the belt wheel frame is loose and the positioning of the shaft is inaccurate. Adjust and reinforce.
9,XXH synchronous belt installation must be in accordance with different models and bandwidth
10,The tensioning wheel must be mounted on the side of the driving loose side.
The synchronous belt drive is a new belt drive which combines the advantages of belt drive, chain drive and gear transmission. Due to work like tooth shape, tooth of the pulley meshing transmission, and by the load on the tensile layer, to maintain with constant pitch line length, so there is no relative sliding between band and pulley, so that the main, driven wheel can do no slip between synchronous transmission. The speed range of synchronous belt transmission ranges from several revolutions per minute to the linear speed of 40m/s, the speed ratio can reach 10, the transmission efficiency can reach 99%, and the transmission power can range from a few watts to hundreds of watts. In recent years, mining, metallurgy, iron and steel machinery, medical equipment demand increasing, synchronous belt transmission is now in a variety of instruments, computer, sewing machines, textile machines, chemical fiber machine, and other widely used in general machinery.
|
specification
|
Section line length
|
Tooth number
|
|
700 XXH
|
1778.00
|
56
|
|
800 XXH
|
2032.00
|
64
|
|
900 XXH
|
2286.00
|
72
|
|
1000 XXH
|
2540.00
|
80
|
|
1200 XXH
|
3048.00
|
96
|
|
1400 XXH
|
3556.00
|
112
|
|
1563 XXH
|
3968.75
|
125
|
|
1600 XXH
|
4064.00
|
128
|
|
1700 XXH
|
4318.00
|
136
|
|
1800 XXH
|
4572.00
|
144
|
